An Aberdeen lumber mill has been fined $112,000 for safety violations following the death of a worker last April. Andrew Ward, 41, of Elma, died when he fell from an elevated platform where he was working to the concrete surface below.
An investigation by the Washington State Department of Labor & Industries has found and cited Sierra Pacific Industries for seven safety violations at the lumber mill where the incident happened, including a “willful violation,” the most serious with the maximum penalty of $70,000 for “not ensuring that an open-sided work platform was adequatel guarded and for not ensuring employees wore fall protection equipment.”
The company has appealed the violations.
“Our first priority is safety,” said Sierra Pacific spokeswoman Lisa Perry. “This was not a willful violation but a tragic accident in which we lost a valued member of our family.”
The state’s investigation found that a section of permanent yellow guardrail was removed from the 17-and-a-half-foot-high platform and replaced with yellow caution tape so that a crane could move some equipment. When Ward went to the edge of the platform to communicate with the crane operator below, he leaned forward and fell.
The investigation found that the employer knew that caution tape cannot be used in place of guardrails at a high elevation, but still regularly allowed it to happen. Additionally, the employer was required to provide workers with a fall protection system, such as a harness, lanyard and tie-off point, while working on the elevated platform without adequate guardrails, and when removing them.
“A death like this is especially tragic because it was completely preventable by using proper fall protection and following safe work practices,” said Anne Soiza, Labor & Industry’s assistant director for the Division of Occupational Safety and Health. “Falls are the leading cause of worker deaths and immediate hospitalizations. Employers need to be vigilant about preventing falls.”
The employer was cited for an additional six serious violations, each with the maximum penalty of $7,000. Those violations covered a range of serious hazards that exposed workers to harm, including ineffective safety and health training; a safety program that wasn’t tailored to company operations; inadequate personal protective equipment training; untrained crane personnel; and not following safety precautions required for open flame work.
Because of the willful violation that led to the death of a worker, Sierra Pacific Industries has been placed on the severe violator list and will be subject to follow-up inspections to determine if the conditions still exist in the future.
